Редактирование: Участник:Drakon721 (раздел)

= Construction =

== Required Tools ==
{| class="wikitable"
|
|Cable Coil, 2x (Two full coils)
|
|-
|
|Steel Sheets, 5x
|
|-
|
|SMES Circuit Board
|May be obtained from Research, or salvaged from existing SMESs.
|-
|
|Superconducting Magnetic Coil
|May be obtained from Cargo or salvaged from existing SMES. You need at least one coil, but adding more coils increases capacity and input/output cap of the SMES. You may add up to six coils into single SMES.
|-
|
|Console Screen
|May be vended by the Robco Tool Maker in the engineering bay.
|-
|
|Input Controller
|May be vended by the Robco Tool Maker in the engineering bay.
|-
|
|Insulated Gloves
|Optional, but recommended (especially if you are going to manipulate wiring)
|}

== Construction Steps ==

# Use your metal sheets to build machine frame.
# Place wire under the machine frame and connect it to a cable line. The SMES will output into this wire.
# Fix the machine frame to the ground with a wrench.
# Use a cable coil on the machine frame to add wires.
# Use a SMES Circuit Board on the wired machine frame.
# Use a screwdriver to finish the machine frame into an SMES.
# (Making sure the maintenance hatch is open) Add 10 pieces of cable to give the SMES a terminal (see “Terminal” section after this one), whatever cable is connected to the terminal on the ground next to the SMES will be the machine’s input.
# Add 30 pieces of cable (one full length cable coil).
# Add one superconducting magnetic coil.
# Install a console screen into the SMES.
# Install an input controller into the SMES.
# Finalize the SMES with a screwdriver.

== Terminal ==
New SMES starts without terminal. Furthermore, terminals may be damaged by explosions or similar effects. Fortunately, installing new terminal is easy.

# Open interface of your SMES and turn it's input and output OFF.
# Use screwdriver on the SMES to open the cover.
# Use cable coil on the SMES to add new terminal. You need 10 pieces of cable for this. If you make a mistake use wirecutters to remove the terminal and repeat this step.
# Use screwdriver on the SMES to close the cover.

== RCON Settings ==
RCON, or Remote CONtrol, allows remote operation of SMESs from RCON console. To allow usage of RCON you have to set RCON tag. This tag has to be unique (ie. do not use tag already used by another SMES). To set new tag click the SMES with multitool. If you wish to disable RCON you may either cut apropriate wire (see Hacking section), or use tag "NO_TAG".