Редактирование: Участник:Drakon721 (раздел)

== Construction Steps ==

# Use your metal sheets to build machine frame.
# Place wire under the machine frame and connect it to a cable line. The SMES will output into this wire.
# Fix the machine frame to the ground with a wrench.
# Use a cable coil on the machine frame to add wires.
# Use a SMES Circuit Board on the wired machine frame.
# Use a screwdriver to finish the machine frame into an SMES.
# (Making sure the maintenance hatch is open) Add 10 pieces of cable to give the SMES a terminal (see “Terminal” section after this one), whatever cable is connected to the terminal on the ground next to the SMES will be the machine’s input.
# Add 30 pieces of cable (one full length cable coil).
# Add one superconducting magnetic coil.
# Install a console screen into the SMES.
# Install an input controller into the SMES.
# Finalize the SMES with a screwdriver.